Change Language :
CFX clamps with stacker saddles for pneumatic hoses
Securely clamp hoses without crushing them
A new clamp for pneumatic hoses hold the hoses reliably without crushing them and thus reducing the cross section. With a new clamp, the cross section of pneumatic hoses is fully retained. At the same time, the hoses are held securely. Due to high sides, the inserts generate a high holding force for pneumatic hoses in the energy chain and prevent them from being crushed.
Tech up
- Protection of pneumatic hoses against crushing and damage, thus no loss of performance
- High holding force due to "all-round grip"
- The cross section of pneumatic hoses is fully retained
- Coloured identification markings (inserts are blue)
Cost down
- Good price-performance ratio
- Fast assembly without checking the tightening torque
- Protection of the pneumatic hoses against crushing and damage
Proof
- Tests performed at our customer Schwäbische Werkzeugmaschinen
- Tensile force tests in the igus laboratory with PU hoses, e.g. diameter 10mm with 165N (further test results upon request)
Sustainability
- Resource conservation: conversion instead of replacement
- Have your energy chain recycled in the igus chainge recycling program at the end of its service life. No matter what manufacturer.
- igus has been an investor in Mura Technology from the beginning and is helping advance chemical recycling. From plastic waste to crude oil in 20 minutes.
