Series E4.42AG - Chain, snap open on both sides with crossbars at every link

Separators can be placed at any point along a chain's cross section. As standard, separators are mounted every 2nd chain link.

• NEW: Split separator T423(A) for use with intermediate shelf 386.X - ideal for subsequent shelving or for the initial assembly of the e-chain®. Hinge/push mechanism for fast assembly and disassembly. Speeds up installation. Enhances flexibility.
   
  
• Standard separator 381 for e-chains® offers safe stability due to its broad foot design, also when used with thick cables or hoses.
   
  
• Vertical separator 3881 with a narrow foot (7 mm) for e-chains® with applications where a large number of small cables need to be individually separated.
   
  
• Separators can be fixed in position by spacers 381.XX for e-chains®. The available inner height is reduced by 2 mm for each spacer and side. To avoid this, the parts can also be mounted on the crossbar from the outside (except in the case of long travels). XX = wide spacers (options: 10, 15 and 20 mm).
   
  
• Locking separator 3804 for e-chains® – with increased retaining force for applications with very high humidity or extreme loads. The increased retaining force is produced by retaining claws positioned asymmetrically to the chain link. Please make sure of an even alignment.
   
  
• Asymmetric separator 381A for e-chains® with an 14-mm base, for combinations between spacers of different widths and vertical separators in side-mounted applications, for instance.
  

For use with many cables of differing diameters. e-chains® and E-Tubes can be subdivided both vertically and horizontally.

• NEW: Split separator T423(A) for use with intermediate shelf 386.X - ideal for subsequent shelving or for the initial assembly of the e-chain®. Hinge/push mechanism for fast assembly and disassembly. Speeds up installation. Enhances flexibility.
   
  
• Side plates 386, separators 388 and intermediate shelves 386.X form the basic grid of a shelving system. Shelves of various widths can be arranged at 5 different heights (in 7 mm increments).
   
  
• For a very fine shelving solution, slotted separator 391 is used. However this cannot be integrated subsequently in an existing division without disassembly of the interior separation.
   
  
• The unilateral open, slotted separator 397 can be retrofitted into an existing interior separation system without a need for dismantling the interior separators. During an installation of open slotted separators, the top and bottom notches cannot be occupied by shelves.

Strain reliefs

Strain reliefs