Series 600, crossbars at every link

Option 1: Vertical separators and spacers

Vertical separators are used if a vertical subdivision of the Energy Chain® interior is required. By standard, vertical separators are assembled every other Energy Chain® link. NOTE: Observe a lateral spacing of at least 1.26 in. (32mm) for Energy Tubes and .63 in. (16mm) for Energy Chain®. There is no minimum spacing needed for side plates Exception: Minimum spacing Locking separator 6008 = .91” (23 mm)

Standard separator 6001 for Energy Chains® and Energy Tubes
This separator offers safe stability due to its wide base design, also when used with thick cables or hoses.

Locking separator 6008 for Energy Chains®
This separator features increased retention force for applications exposed to very high humidity and extreme loads. The extra retention force is achieved by asymmetric claws for the crossbar. Take care to ensure proper alignment.

NOTE ON SPACERS
Vertical separators are adjustable, but can be fixed in position by means of a spacer. Spacers are most often necessary for side mounted applications. The available inner height is reduced by .08” (2mm) per spacer (for example if one spacer is placed on either side of the separator, the overall inner height is reduced by .16” (4mm). To avoid this, place the spacers on the outside of the opening crossbar (not for long travels).

Option 2: Shelves

Energy Chains® and Energy Tubes can be subdivided both vertically and horizontally using the various interior separation elements.

Side plates 6002
This component is used to form the basic pattern of a shelf system.

Vertical separator 6003
This component is used to form the basic pattern of a shelf system.

Locking vertical separator 6010
This separator is slotted and able to be combined with shelves

Slotted separators 6004
These are used for very complex subdivisions. However, they cannot be retrofitted into an existing separation system without removing the shelves first.

Slotted separator 6005
This separator can be retrofitted into an existing interior separation system without removing the shelves, as long as these shelves fit into any of the 11 middle slots

Shelves 420-XX
These components form the basic pattern of a shelf system. Shelves of various widths can be arranged at 7 different heights in .28” (7mm) increments

Strain reliefs

+ Easy assembly with installation sets
+ 2-part design - adaptable to chain widths
+ Very stable
+ Economical
+ Large selection

Guide trough without glide bars part no. 98-30, guide trough with glide bars part no. 98-31

Installation sets as a joint connection part no. 98-50. XX