iglide® J3: runs longer

iglide® J3 is our new material with increased wear resistance at low to medium loads and high speeds. The service life is up to 300% higher than in iglide® J, the proven top endurance runner material.

iglide® J3 is available as cylindrical bushings and plain bushings with flange.

Available upon request

Personal contact

Ask the product expert

Variants

Sleeve bushing (metric sizes)

Flange bushing (metric sizes)


Part No. :
Shaft diameter d1 [inch]:
Bearing length b1 [inch]:
Outer diameter d2 [inch]:
d1-Tolerance min. [inch]:
d1-Tolerance max. [inch]:

(Dimension according to ISO 3547-1 and special dimensions) Recommended tolerance for the installation: Housing bore H7, Shaft h9. The tolerance for d1 is applicable for bushings that are press-fitted in a steel housing bore in the nominal dimension H7. For b1, tolerance field h13 is applicable .

Chamfer depending on d1

d1 [mm]:	Ø 1-6	Ø 6-12	Ø 12-30	Ø > 30
f [mm]:	0,3	0,5	0,8	1,2

With the selected part you'll arrive at:

PDF file 3D-CAD Samples and catalog order

Application examples

Material data

Life time calculation

test method

installation

GToB Imprint General notes Data protection declaration


Part No. :
Shaft diameter d1 [inch]:
Bearing length b1 [inch]:
Flange thickness b2 [inch]:
Outer diameter d2 [inch]:
Flange diameter d3 [inch]:
d1-Tolerance min. [inch]:
d1-Tolerance max. [inch]:

d1 [mm]:	Ø 1-6	Ø 6-12	Ø 12-30	Ø > 30
f [mm]:	0,3	0,5	0,8	1,2